[ENG] 8.2 [DKSF 48.5 IU] I Want to Configure the Sending of Notifications for Events About the Operation of the Relay. How to Do It?

In order to configure the notifications about the operation you need to open the "AC OUTLETS" page of the device`s web interface:

When you click on the “Setup” button, a settings menu appears for sending notifications of the following types: Log, Syslog, Email, SMS and SNMP Trap:

Commands for Switching On/Off — a checkbox, when available, notifications will be sent when the device receives a command to change the state of the relay.

Reset (Flip for Short period)  — a checkbox, when available, the notifications will be sent when the relay is turned on / off briefly.

Suspention of the Resets in Watchdog — a checkbox, when available, the notifications will be sent if suspensions are paused by the Watchdog, when the configured value of the number of suspentions is reached.

Relay Switched — a checkbox, when available, the notifications will be sent if the physical state of the relay changes.  

Include in Summary Report   a checkbox, when available, the relay status reports will be sent by email, SMS and/or SNMP Trap. The time for sending reports is indicated on the “SMS” and “EMAIL” pages, the setting for periodic sending of SNMP Trap is indicated on the “SETUP” page in the “SNMP TRAP” section.

Using the “Use a common snmpTrapOID for all events” and “Use a common snmpTrapOID for Sensor Numbers” checkboxes you can send all events from all relays to a single snmpTrapOID message or to split events and relay channel numbers by different snmpTrapOID messages, up to completely individual ones. This allows you to receive individual SNMP Trap messages for processing them in monitoring systems.

Usually, snmpTrapOID of the type .1.3.6.1.4.1.25728.5500.6.127.99 is used, while parsing variable values in the Trap message is required to determine the notification source and event. If the device or software that receives SNMP Trap cannot perform variable checking, it is possible to include the event code and/or relay number directly in snmpTrapOID and so receive unique SNMP Trap notifications for each event on each sensor.

 The decryption of the events types can be switched off by eliminating the tick in “Use a common snmpTrapOID for all events”, in this case the Trap-message will look like:

.1.3.6.1.4.1.25728.5500.6.S.99, where S — an event, possible values: 100 (Off), 101 (On), 102 (the command fo the relay state change has been received), 103 (the reset of the relay has been started);

The decryption of the events types can be switched off by eliminating the tick in “Use a common snmpTrapOID for all Sensor Numbers”, in this case the Trap-message will look like:

.1.3.6.1.4.1.25728.5500.6.127.N, where N — a  relay number, from 1 to 8.

Trap contains the variable values (varbind list) described in the section [ENG] 14.4. [DKSF 48.5 IU] The Support of SNMP trap.

After configuring all the settings press "Save" button.