[ENG] 14.2. [DKSF 48.5 IU] Configuration of Sending SNMP TRAP Messages

To send  TRAP messages via SNMP v1 protocol using this device, it is necessary to configure the following parameters on the "SETUP" page of the web interface:

  • SNMP Trap Destination #1, Port —an IP address where TRAP messages will be sent to. It is indicated on the “SETUP” page of the device`s web-interface;
  • SNMP Trap Destination #2, Port  —  the second (optional) IP address where TRAP messages will be sent to. It is indicated on the “SETUP” page of the device`s web-interface;

Periodic Sending of Traps — configuring the period for sending periodic SNMP TRAP sensor status messages. To enable sending such a TRAP message, you must switch on the corresponding checkbox in the notification settings dialog of the sensor you need. Possible values: 5 minutes, 10 minutes, 15 minutes, 30 mnutes, 1 hour, 2 hours, 4 hours. In Default: off.